 |
|
|
|
|
3G HSDPA I/O Features and Benefits
- Universal tri-band UMTS/HSDPA 850/1900/2100 MHz with IPSec/
VPN support - Definable cellular connection strategy to optimize data transmission
- Intuitive menu driven front-end intelligence
- Flexible, Unicode alarm system supporting SMS, email, SNMP Trap, TCP, UDP
- One RS-232/422/485 serial port built in to connect with field serial devices
- Backup and sustainable data logging function
- Seamless SCADA connectivity by Active OPC technology
- Configure, update firmware, and program over the air via ioAdmin
- Windows/WinCE VB/ VC.NET and Linux C APIs
- -20 to 70°C operating temperature range (T model)
Introduction
The Moxa ioLogik W5340- 3G HSDPA micro controller is a rugged, compact solution for remote monitoring and alarm systems. With the Moxa ioLogik W5340- 3G HSDPA, you can define a cellular connection strategy, including Always-On and Wake-On-Demand, to optimize data transmission rates for different applications. In addition, the operational cost of cellular communication depends on the data transmission rate. With Moxa’s active technology, you can expect to cut transmission costs in half and offer different cellular connection strategies to achieve better data transmission fees.
This rugged, wide temperature, compact solution is suitable for the following applications:
- Water and wastewater industries
- Broadcast and telecom radio tower monitoring
- Infrastructure management
- Oil & gas, power, and transportation
- Lighting control monitoring
| • Cellular interface: | |
| Interface | GPRS |
| Band Options |
Tri-band UMTS/HSDPA 850/1900/2100 MHz Quad-band GSM/GPRS/EDGE 850/900/1800/1900 MHz |
| GPRS Multi-Slot Class | Class 10 |
| GPRS Terminal Device Class | Class B |
| SMS | Point-to-Point Text/PDU |
| SIM Interface | 3 V |
| • Serial communication: | |
| Interface |
1 x RS-232/422/485, software selectable (9-pin D-Sub, male or 5-contact terminal block) |
| Baudrate | 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 bps |
| • LAN: | |
| Ethernet | 1 x 10/100 Mbps, RJ45 |
| Protection | 1.5 KV magnetic isolation |
| Protocols | Modbus/TCP, TCP/IP, UDP, DHCP, Bootp, SNMP, SNTP |
| • ANALOG INPUT: |
|
| Channels | 4 analog inputs with differential input |
| Resolution |
16 bits |
| I/O Mode | Voltage / Current |
| Input Range |
0 to 10 V, ±10 V, ±5 V, 0 to 20 mA, 4 to 20 mA |
| Accuracy | • ±0.1% FSR @ 25°C • ±0.3% FSR @ -10 and 55°C |
| Sampling Rate (all channels) | 100 samples/sec |
| Input Impedence | 200K ohms (min.) |
| Built-in Resistor for Current Input | 102 ohms |
| • di/DO CONFIGURABLE CHANNELS: |
|
| Channels | 8 |
| I/O Mode | • DI or Event Counter (up to 900 Hz) • DO or Pulse Output (up to 100 Hz) |
| • Digital INput: |
|
| Channels |
Up to 8, source/sink selectable |
| Sensor Type | NPN/PNP type |
| I/O Mode | DI or Event Counter (up to 900 Hz) |
| Dry Contact | • Logic 0: short to GND • Logic 1: open |
| Wet Contact | (For Source Type) • Logic 0: 0 to 3 VDC • Logic 1: 10 to 30 VDC (For Sink Type) • Logic 0: 10 to 30 VDC • Logic 1: 0 to 3 VDC |
| Common Type | 4 points per COM |
| Isolation | 3K VDC or 2K Vrms |
| Counter/Frequency | 900 Hz, power off storage |
| Digital Filtering Time Interval | Software selectable |
| Over-voltage Protection | 36 VDC |
| Poweroff Counter Memory | Supports poweroff counter storage function |
| • Digital output: |
|
| Channels | Up to 8, sink type, 36 VDC, 200 mA |
| I/O Mode | DO or Pulse Output (up to 100 Hz) |
| Pulse Wave Width/Frequency | 10 ms/100 Hz |
| Over-voltage Protection | 45 VDC |
| Over-current Limit | 600 mA |
| Over-temperature Shutdown | 160°C |
| Output Current Rating | Max. 200 mA per channel |
| Isolation | 3K VDC or 2K Vrms |
| • relay output: |
|
| Channels | 2 Form A (Normal Open) relay outputs, 5 A |
| Contact Rating | 5 A @ 30 VDC, 5 A @ 240 VAC, 5 A @ 110 VAC |
| Inductance Load | 2 A |
| Resistance Load | 5 A |
| Breakdown Voltage |
500 VAC |
| Relay On/Off Time | 10 ms, 5 ms (max.) |
| Initial Insulation Resistance | 1G min. @ 500 VDC |
| Expected Life | 100,000 times (Typical) |
| Initial Contact Resistance | 30 milli-ohms (max.) |
| Pulse Output | 20 operation times per minute at rated load |
| Isolation | 3K VDC or 2K Vrms |
| • Physical Characteristics: |
|
| Weight |
495 g |
| Dimensions | 46.8 x 135 x 105 mm (1.84 x 5.31 x 4.13 in) |
| • power requirements: |
|
| Power Consumption | •GPRS Always On (Communication): 4.2 W •GPRS On Demand: 2.8 W |
| Power Input | 24 VDC nominal, 12 to 36 VDC |
| • Environmental Limits: | |
| Operating Temperature |
Standrad Models: -10 to 55°C (14 to 131°F) Wide Temp. Models: -20 to 70°C (-4 to 158°F) |
| Storage Temperature | -40 to 85°C (-40 to 185°F) |
| Ambient Relative Humidity | 5 to 95% (non-condensing) |
| • regulatory Approvals: | |
| Safety | UL 508 (Pending) |
| EMI | FCC part 15, CISPR (EN55022) Class A |
| EMS |
IEC 61000-4-2 (ESD), levels 2, 3 IEC 61000-4-3 (RS), level 2 IEC 61000-4-4 (EFT), level 2 IEC 61000-4-5 (Surge), level 3 IEC 61000-4-6 (CS), level 2 IEC 61000-4-8 (PM), level 1 IEC 61000-4-11 (DIP) IEC 61000-6-2 (ESD), levels 2, 3 IEC 61000-6-4 (EFT), level 2 |
| Shock | IEC 60068-2-27 |
| Freefall |
IEC 60068-2-32 |
| Vibration | IEC 60068-2-6 |
| • Warranty: | |
| Warranty Period | 2 years |
| Details | See www.moxa.com/warranty |
Available Models
| Ordering Info | Model No. | Descritpion |
| Click here to order |
ioLogik W5340-HSDPA |
HSDPA Micro Controller with 4 AIs, 8 DIOs, and 2 relay outputs |
| Click here to order |
ioLogik W5340-HSDPA-T |
HSDPA Micro Controller with 4 AIs, 8 DIOs, and 2 relay outputs,-20 to 70°C operating temperature |
